pic: 6WD Riveted Frame Development

11-08-2008, 18:31

bigbeezy

Registered User

AKA: Bryan

FRC #2338 (Gear it Forward)

Team Role: Coach

Join Date: Dec 2006

Rookie Year: 2005

Location: Oswego, IL

Posts: 310

Re: pic: 6WD Riveted Frame Development

Now I do have one question.

Is that U-channel or Rectangle Tubing where the wheels are mounted? Now someone with more experience with cantilevered wheels correct me, but don't you need a place for 2 bearings to support the axle? If it is indeed tubing then never mind.

__________________
Team 1592 Bionic Tigers -- Driver 2005-2008
Winner - Florida Regional 2005
Finalist - Newton Division 2007
Winner - Colorado Regional 2008
Florida State University - BS Mechanical Engineering
Team 2338 Gear it Forward -- Mentor/Drive Coach 2013-Present
Winner - Wisconsin Regional 2013
Chairman's Award - Midwest Regional 2015
Winner - Archimedes Sub-Division 2015
Chairman's Award - Midwest Regional 2016

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: 1760 - 6WD with OMNI wheels	Mark Pendergast	Extra Discussion	1	20-03-2008 19:35
pic: Frame is	falconmaster	Extra Discussion	1	17-01-2008 23:11
pic: 6WD Design Iteration	Madison	Extra Discussion	7	01-01-2008 14:00
pic: 6WD Module	Madison	Technical Discussion	20	12-01-2007 10:09
pic: Isometric View of A 6WD module	Cody Carey	Extra Discussion	8	04-01-2007 17:19

All times are GMT -5. The time now is 11:54.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.