|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: pic: Ball Harvester
I like your design but there is another rule that the bumpers must make first contact with the wall... I think your outside bumper corners should prevent your rollers from hitting the wall first... so that should be ok.
I would be careful though as another robot or trailer can hit the roller area... with the corner of their robot.. I can speak from experience in 2006 with a front roller that picked up the poof balls... It was an issue then.. but of course ... in 2006 we didn't have mandated bumpers on the robot... just suggested...so we took many hits from unbumpered robots. We ended up having to use a titanium bar to protect our roller. Good luck with your design... I hope it works great!! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: CD 7 ball harvester | BlazinFire47 | Extra Discussion | 21 | 14-05-2012 09:56 |
| Knocking off a ball while possesing a ball | Joe Ross | Rules/Strategy | 25 | 10-03-2008 18:49 |
| WHere do you get Ball Casters/ BAll Transfers for FRC?!?!?!? | leehyungjin4u | General Forum | 3 | 15-01-2008 23:27 |
| Chief 47 ball harvester 2002 pics | ajlapp | Robot Showcase | 6 | 11-01-2006 15:34 |
| 2X Ball Into the Ball Release | MikeDubreuil | Rules/Strategy | 23 | 28-03-2004 19:31 |