|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#35
|
|||||
|
|||||
|
Re: pic: Ball Harvester
OK, we have beaten to death. We will change our bot's front to have a six inch flat side on each side of our harvester's opening. It looks like it will not make too much of a difference , only ball's a ball width. We will just have to drive better! It was great watching all you debate the issue though, but if we stay with our design, we will loose the argument. We will bring our old angled side however in case we see the inspectors change their interpretation. Thanks all.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: CD 7 ball harvester | BlazinFire47 | Extra Discussion | 21 | 14-05-2012 09:56 |
| Knocking off a ball while possesing a ball | Joe Ross | Rules/Strategy | 25 | 10-03-2008 18:49 |
| WHere do you get Ball Casters/ BAll Transfers for FRC?!?!?!? | leehyungjin4u | General Forum | 3 | 15-01-2008 23:27 |
| Chief 47 ball harvester 2002 pics | ajlapp | Robot Showcase | 6 | 11-01-2006 15:34 |
| 2X Ball Into the Ball Release | MikeDubreuil | Rules/Strategy | 23 | 28-03-2004 19:31 |