|
|
|
 There are "Problems", and then there are "Solutions". Understand the Problem, and keep your mind open to alternative solutions. Don't get married to a Solution. - rich2202 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
31-01-2009, 20:13
|
||||
|
||||
|
Re: pic: Team 617 Robot
From what i can tell it looks like the frame is much thinner in the back then in the front, but bumpers in the front will be a must (if you place bumpers on the vertex of the front corners[you need to] that should remove most problems)
But if your not long enough you would have a problem seeing as your front is angled in bumpers there would not count to your 2/3 rules, and if they were made straight out from the angled section they wouldn't be supported... so in that respect i agree, you may have some trouble with bumper rules 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 617 Inventor Robot | rohit | Extra Discussion | 4 | 14-02-2008 16:22 |
| pic: So far.. inventored robot. Team 617 | rohit | Extra Discussion | 9 | 27-02-2007 21:46 |
| pic: Team 617 Controller | rohit | Extra Discussion | 1 | 21-02-2007 13:08 |
| pic: Team 617 Robot | rohit | Robot Showcase | 7 | 21-02-2007 13:04 |
| pic: Team 617 Robot Remp (Inventor) | rohit | Extra Discussion | 18 | 14-02-2007 10:54 |
Threaded Mode