|
|
|
 Well I guess that's better than some teams idea of team bonding which would be taping a wayward freshman to the wall with duct tape. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Well I guess that's better than some teams idea of team bonding which would be taping a wayward freshman to the wall with duct tape. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: FRC-34 2009 Frame Concept (Front View)
Quote:
 well we're planning on doing one of these(basically the limit of our machining capabilities) http://www.chiefdelphi.com/media/photos/32459 we're just trying to figure out how to support it from both ends easily.... so i was thinking a 2 large Lazy-Susan's that we can bolt a plate onto each side, so we can then attach the module itself at the top and bottom, As well at attach it to a Kit-Frame(05') without having to modify it too much.... 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: FRC-34 2009 Swerve Module w/CIM (Front View) | Ed Sparks | Extra Discussion | 10 | 05-05-2009 07:13 |
| pic: FRC-34 2009 Swerve Module w/FP (Side View) | Ed Sparks | Extra Discussion | 6 | 09-03-2009 14:02 |
| pic: FRC-34 2009 Frame Concept (Bottom View) | Ed Sparks | Extra Discussion | 1 | 09-03-2009 12:11 |
| pic: FRC-34 2009 Frame Concept (Rear View) | Ed Sparks | Extra Discussion | 2 | 09-03-2009 11:00 |
| pic: Concept Frame | armoredvehicle | Extra Discussion | 6 | 16-12-2007 20:55 |
Hybrid Mode
