|
|
|
 FIRST like life is what you make of it, if you would rather go through FIRST worrying about what other teams do to make their robots, then your destined for disappointment. if you go through FIRST making the most of it doing the best you and your team can then it doesn't matter what other teams do. - Mike Schroeder [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
17-06-2009, 23:57
|
||||
|
||||
|
Re: pic: Team 1927's swerve module
wow lot of questions the walls are 3/16" thick and the shafts are 1/2"
bearing and all it ways about 6 lbs. a piece i think we used set screws this year and that was our biggest problem was them coming loose as well as throwing chains so next year were going to go with roll pins for SURE!! ha we are also going completely away from chains and using all belts there much simpler!! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 221 LLC. - Wild Swerve Module | ajlapp | Extra Discussion | 77 | 06-11-2009 17:33 |
| Team 1927's swerve module | BlackBird11891 | Technical Discussion | 2 | 16-06-2009 16:35 |
| pic: Team 148 Robowranglers: Swerve Module and Motors | Brandon Martus | Robot Showcase | 27 | 24-02-2008 22:29 |
| pic: Swerve! (Module) | =Martin=Taylor= | Extra Discussion | 13 | 09-07-2006 19:57 |
Threaded Mode