pic: Wild Swerve Module, Near Production

Chris Fultz · #1 03-08-2009, 22:38

Quote:

Originally Posted by samir13k

what are the gears used in this? and what is the final reduction also? thanks

Anthony can give the details, but the gears are standard AndyMark. There are multiple combinations that can be used to give several different final drive ratios.

ajlapp · #2 03-08-2009, 23:45

Quote:

what are the gears used in this? and what is the final reduction also? thanks

The gears used are standard Andymark.

All ratios start with a 14 tooth CIM gear to a 35 tooth .375" hex gear.

The remaining gears can be any that follow the Toughbox spread of 64 teeth max.

There are many ratios possible, the four most relevant using the CIM are as follows:

14.8:1 or about 4.8 ft/sec at max power
9.87:1 or about 7.2 ft/sec at max power
6.94:1 or about 10.36 ft/sec at max power
5.36:1 or about 13.4 ft/sec at max power

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Team 221 LLC. - Wild Swerve Module	ajlapp	Extra Discussion	77	06-11-2009 17:33
pic: Swerve Module Concept (View 2)	Dave McLaughlin	Extra Discussion	5	17-06-2009 00:15
pic: stangs swerve module	Aren_Hill	Extra Discussion	8	23-04-2007 08:15
pic: Swerve! (Module)	=Martin=Taylor=	Extra Discussion	13	09-07-2006 19:57