|
|
|
 We did the best job we could out there, and unfortunatly we have human limits.. The refs don't catch every penalty, inspectors don't catch every issue, and this year the score keepers won't catch every single ball. - nobrakes8 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#8
03-12-2009, 12:55
|
||||
|
||||
|
Re: pic: Modified/Integrated Transmission
Thanks for the input ajlapp, I think we'll take the advice to allow us to pull the motors out without banging at em with a flathead first.
Here is a picture of the mounting plate. Things circled in red are motor mounts. Things circled in purple are where the spacers go. The bit circled in lime-green are the two reductions for the gearbox. http://s169.photobucket.com/albums/u...ntingplate.png We ended up keeping the mounting holes the same dimensions as the TB so if things go south we can just bolt a pre-assembled toughbox on and keep on rolling. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Modified Andy Mark 2 speed gearbox | sam shawe | Extra Discussion | 3 | 29-04-2011 00:22 |
| pic: 1213 GROVES modified tough box | groves | Extra Discussion | 12 | 09-02-2009 10:30 |
| pic: re-modified 6wd | spc295 | Extra Discussion | 15 | 19-11-2008 15:14 |
| Running Inventor on an eMachines Celeron with integrated graphics | sanddrag | Inventor | 4 | 25-11-2005 08:42 |
| pic: A nikko RC car, modified | Andy A. | Extra Discussion | 11 | 20-03-2005 11:59 |
Threaded Mode