|
|
|
 No one said that this would be easy. And if they did, they were obviously refering to a little red button from Staples and not to FIRST. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| No one said that this would be easy. And if they did, they were obviously refering to a little red button from Staples and not to FIRST. - artdutra04 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
27-04-2010, 16:58
|
|||
|
|||
|
Re: pic: Sheet Metal Drivetrain
Are there any flanges on those cross members or spacer plates in between the blue drivetrain plates? That can easily add a lot more rigidity.
Last edited by Akash Rastogi : 27-04-2010 at 17:05. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What do you do with a sheet metal laser cutting sponsor? | mikelowry | Robot Showcase | 4 | 05-02-2010 22:40 |
| Left and Right configurations with Sheet Metal | AustinSchuh | SolidWorks | 5 | 26-01-2010 02:24 |
| pic: GUS Team 228's 6WD Sheet Metal Prototype Chassis | artdutra04 | Extra Discussion | 14 | 02-01-2009 02:11 |
| New Sheet Metal Pattern Query | easydub | Inventor | 4 | 13-07-2006 13:55 |
| [OCCRA]: Bending Sheet Metal | troy_573 | OCCRA Q&A | 1 | 19-09-2005 22:27 |
Threaded Mode