pic: Enigma Wheel

[Rion Atkinson]

Originally Posted by kgzak

Yup, I wasn't planning on anything with these wheels except to learn a little about CAD.

It's always good to start with CAD early by playing around with it and doing small projects. It makes it a lot easier come build season.

Wheel is 1.5in deep, 6in wide
Spokes are .5in deep, .25in wide
Any other measurements you would like?

Okay, yeah those spokes wont break at that size. Though when you say that the wheel is 6in wide I assume you mean the diameter is 6 inches?

Are you running Inventor? I haven't been able to get a hold of Solidworks or Inventor recently so I can't remember which one has the 3 axis in the bottom that looks like that.

New picture edit: I don't know if the spokes have enough contact with the wheel. I also think you may be ale to pull weight out of the hub there.