|
|
|
 Successful teams - in almost any aspect of life (i.e. not just robotics) - don't make excuses and assign blame when something goes wrong. They improvise. They adapt. They overcome. They correct the problem and move on. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
07-10-2010, 21:23
|
||||
|
||||
|
Re: pic: Belt Drive Chassis Take 2
as long as the belt has an even number of teeth, and the distance between the center to the two outer pulleys is exactly equal, the teeth will line up on top and bottom.
oh, and the number of teeth on the center pully must also be even Last edited by Hawiian Cadder : 07-10-2010 at 21:24. Reason: realized i was wrong 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Belt Drive Chassis | Sh1ine | Extra Discussion | 11 | 07-10-2010 07:11 |
| pic: Schreiber Take on West Coast Drive | Andrew Schreiber | Extra Discussion | 69 | 23-08-2010 00:36 |
| pic: FRC488 - Six Wheel Drive Chassis | Madison | Technical Discussion | 38 | 23-01-2007 10:58 |
| Chain drive vs. cogged belt drive(timing belts) | LordBritten | Technical Discussion | 24 | 20-12-2006 23:07 |
| pic: Belt drive 1559 | krADLEY | Robot Showcase | 8 | 01-02-2006 21:37 |
Threaded Mode