pic: How 125 is rolling this year...

[Brandon Holley]

Originally Posted by Bruceb

So, to make the mold you just laid the master on the bottom of the mold box and poured the silicone over it? The top side of the wheel is as smoothe as the urethane was poured, correct? Or did you pour it high and machine off the excess?
Bruce

The mold "box" base was an aluminum plate with the bolt hole pattern drilled into it. This was then used to hold the master (aluminum) wheel down to the plate. I then hot glued a bucket with the bottom cut off around the wheel.

Yes, the top side is as smooth as the urethane is poured. Some of our wheels have just the poured urethane surface on top. As we tweaked the process though, we added more glass to the urethane, which resulted in a "bumpier" surface on the top. To enhance the look of the wheels we did start pouring high and machining the excess away. One of the enhancements to the process we are trying to make is to eliminate that step, although it only takes a minute or 2 for that operation per wheel.

-Brando