|
|
|
 What we may be looking at is a confusing situation and that can be confusing. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| What we may be looking at is a confusing situation and that can be confusing. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#19
04-01-2011, 13:09
|
|||||
|
|||||
|
Re: pic: GUS Team 228's Prototype Sheet Metal 6WD Chassis
Searching "rubber wheels" in mcmaster brings up the page
Colson Performa (the wheels in this thread) are on the lower half of the page titled "Performance rubber wheels" We used the 3"x7/8ths wide ones in the 4 corners of our 6wd swerve this last year, live axle 3/8ths hex hub, and 3 bolts going through the wheel and hub. The hub was a simple 1.25" diameter .1" ish wide flange, 3 bolt pattern with a smaller diameter that went through the wheel hub. Not having to worry about retreading is nice. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 6WD Sheet Metal | kajeevan | Extra Discussion | 5 | 03-09-2010 19:02 |
| pic: sheet metal 6WD | kajeevan | Extra Discussion | 23 | 23-06-2010 10:20 |
| pic: 6wd prototype chassis | Collin Buchan | Extra Discussion | 7 | 03-01-2009 10:00 |
| pic: 6wd prototype chassis | Collin Buchan | Extra Discussion | 3 | 02-01-2009 14:14 |
| pic: GUS Team 228's 6WD Sheet Metal Prototype Chassis | artdutra04 | Extra Discussion | 14 | 02-01-2009 02:11 |
Threaded Mode