Help with Gearboxes - Chief Delphi

30-12-2002, 00:50

D. Gregory D. Gregory is offline

FIRST Junkie

no team (UHS Wolfpack)

Team Role: Alumni

Join Date: Dec 2002

Location: Toronto, Canada

Posts: 104

D. Gregory is an unknown quantity at this point

Help with Gearboxes

I am in charge of my team's engineeing section and I am contemplating of machining 2 gearboxes (1 per side) to connect 2 motors to one output essentially driving each side with 2 motors. Keep in mind that this will be designed entirely by students but will be machined by professionals. Can you guys give me some tips and suggestions as to the feasibility of this (I know its possible, but is it over the head of a student) and ways I can go about doing this. Thank you very much.

__________________
Duct tape is the force that holds the universe together. Everywhere except FIRST that is.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Which team do u think used firsts gearboxes the best.	18voltMilwauke	General Forum	5	17-04-2003 12:01
Spacers in FIRST gearboxes	Dr.Bot	Motors	11	02-02-2003 20:49
team 151's gearboxes	Greg Perkins	General Forum	3	29-01-2003 23:01
Trade - have Bosch gearboxes, need motors	Andy Baker	Motors	0	24-01-2003 08:32
Drill Motor Inconsistency	archiver	1999	10	23-06-2002 22:34

All times are GMT -5. The time now is 00:16.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.