Drill Motor Mount Experence

Maybe you should whack it a few times with a hammer. That always seems to fix our robots. - Adam Y. [more]

		Chief Delphi > Technical > Motors
Drill Motor Mount Experence

Thread Tools

Rate Thread

Display Modes

02-02-2003, 21:10

ROB at RAGE ROB at RAGE is offline

Registered User

#0173

Join Date: Nov 2002

Location: East Hartford CT

Posts: 16

ROB at RAGE is an unknown quantity at this point

Drill Motor Mount Experence

Has anyone had problems with the Kit Motor mounts?

Theres been a lot of chat about the gear boxes and shaft couplings, but have not heard much about the motor mounts them selves.

We noticed that they are warpted and needed to clamp them down to a bench to measure shaft center line spacing and such.

Thanks,

Rob at Rage

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Portable cordless drill press	Gui Cavalcanti	Technical Discussion	25	03-08-2003 22:21
drill motor mounts- again	Jeff Sharpe	Motors	6	07-04-2003 23:20
Emergency drill trade/sell	Anarkissed	General Forum	3	16-02-2003 22:37
A new record for breaking a drill motor	ZacharyD	Technical Discussion	23	16-01-2003 16:58
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32

All times are GMT -5. The time now is 12:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.