Tapped Drill motor holes: thread anyone?

I was outvoted by conservative teenagers (curse them...). - Rick TYler [more]

		Chief Delphi > Technical > Motors
Tapped Drill motor holes: thread anyone?

Thread Tools

Rate Thread

Display Modes

16-01-2002, 02:20

joe_balint joe_balint is offline

Registered User

FRC #3324 (Metrobots)

Team Role: Engineer

Join Date: Jan 2002

Rookie Year: 1997

Location: Columbus, OH

Posts: 24

joe_balint is an unknown quantity at this point

Tapped Drill motor holes: thread anyone?

I don't want to re-thread the tapped holes on the front (non-terminal) side of the drill motors, but I can't read the print, it's late, and I don't have the hardware here at home. Can anyone tell me what the thread is on these bad boys? I'm going to figure it out eventually, but the less time I spend hunting for screws to chop down the better. Thanks. -Joe

__________________
Engineer
joe.balint@gmail.com
http://www.OhioValleyTesting.com/
"The greatest enemy of a good plan is the dream of a perfect plan." -Clausewitz 1832

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Remember that thread? [08-19-03]	Ken Leung	General Forum	5	23-08-2003 21:34
Portable cordless drill press	Gui Cavalcanti	Technical Discussion	25	03-08-2003 22:21
drill motor mounts- again	Jeff Sharpe	Motors	6	07-04-2003 23:20
Emergency drill trade/sell	Anarkissed	General Forum	3	16-02-2003 22:37
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32

All times are GMT -5. The time now is 07:27.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.