|
|
![]() |
![]() |
|
|||||||
|
![]() |
Thread Tools | Rate Thread | Display Modes |
#1
![]() |
||||
|
||||
![]() Our Talon SR motor controllers from the 2015 KOP are not functioning properly. Everything is wired and programmed correctly. When I enable them, they have no change in the indicator light. It flashes an orange light just like the other motor controllers, but when I enable it the Talon SRXs quit blinking, but the Talon SRs keep blinking. Any help would be greatly appreciated.
|
#2
![]() |
||||
|
||||
Re: Talon SR not working
Make sure the pwm wires aren't plugged in backwards. The side with a small B in the plastic should have the black/brown wire. That wire should correspond to the ground connection on the Rio.
Are you sure that it's programmed correctly... make sure that you have the correct port in software. |
#3
![]() |
||||
|
||||
Re: Talon SR not working
Quote:
|
#4
![]() |
||||
|
||||
Re: Talon SR not working
What did you do to get them to work?
Share with the community. |
#5
![]() |
||||
|
||||
Re: Talon SR not working
I had the PWM Cables plugged in backwards. I had the white part of the cable to the B end. I reversed it to where the black end was plugged in to B.
|
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|