|
|
|
 I then asked if I could use a flux capacitor for power, but that didn't go over too well, either (they did say I could use it for decorative purposes, though). - Kevin Watson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Innovation First DASHBOARD Picture
Posted by Innovation First, Inc.
Engineer on team #883 from Texas. Posted on 12/14/99 7:33 PM MST You can see a sneak peek of our beta Dashboard Viewer on our web site. Go to www.innovationfirst.com and follow the link. The Dashboard connector on the Operator Interface is a transmit only RS-232 port. You can connect it directly to a PC via a 9-pin cable. The current version was written in Visual Basic and requires a 233MHz Pentium. To make it work on slower PCs, we are trying to rewrite it in C before the competition begins (no promises). And yes . . . it will be free. If you have any suggestions or comments, speak now. E-mail them to info@innovationfirst.com. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| miroboworks dashboard program? | archiver | 2000 | 3 | 23-06-2002 23:04 |
| Dashboard Decoder Release Version 1.0 Now Available! | archiver | 2000 | 1 | 23-06-2002 22:50 |
| Innovation First is accepting pre-orders for the Control System | archiver | 2000 | 5 | 23-06-2002 22:19 |
| New Innovation FIRST control system and the dashboard | archiver | 2000 | 0 | 23-06-2002 22:15 |
| Are you willing to let others take picture of your robot? | Ken Leung | Robot Showcase | 21 | 10-04-2002 22:50 |
Threaded Mode