Soldering Wires to Motors

Without programmers there would only be a robotic beauty contest. - mallot1243 [more]

		Chief Delphi > Technical > Motors
Soldering Wires to Motors

Thread Tools

Rate Thread

Display Modes

10-02-2012, 15:34

ChuckDickerson ChuckDickerson is offline

Mentor / Bayou & CMP Division LRI

FRC #0456 (Siege Robotics)

Team Role: Mentor

Join Date: May 2004

Rookie Year: 2004

Location: Vicksburg, MS

Posts: 877

ChuckDickerson has a reputation beyond repute

Soldering Wires to Motors

Does anyone have any good advise on the best way to solder wires to the FP, Banebots (775, 550,...), etc. motor terminals. I am looking for best electrical practices. They can be a little difficult to solder 12GA or 14GA wire to. We have used 3/16" female spade connectors and soldered those onto the wire and terminals in the past but I am looking for better ideas. Anyone have any?

Last edited by ChuckDickerson : 10-02-2012 at 16:04.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:02.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.