How to setup the operator console io

Cooling fans? Never had the need. Then again, we're talking New Jersey in March. Radiant heaters might be a better choice, or maybe snow boots. - DonRotolo [more]

		Chief Delphi > Technical > Control System
How to setup the operator console io

Thread Tools

Rate Thread

Display Modes

24-02-2012, 14:37

agartner01 agartner01 is offline

Captain + Control Sys & Design

FRC #4174

Team Role: Engineer

Join Date: Feb 2012

Rookie Year: 2012

Location: Hector MN

Posts: 109

agartner01 is an unknown quantity at this point

How to setup the operator console io

So now that build seasons over, I've decided to start work on the operator console. I was hoping someone could share their experience in this area. I have two questions:

Do you have to use a breadboard, I recall reading that, but can't find it anywhere in the rules...
Anything wrong with just doing it like this with jumper wire and capping the grounds together?

Edit: 1 more question, anyone know how to get the buttons on the driver station io tab to work?

Last edited by agartner01 : 24-02-2012 at 14:39.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:23.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.