|
|
|
 Welcome to adulthood.
Remember, patience is your friend. Denial is your shield. Bitter disinterest your salve. Your endless hours of crushing workload will be your strength.
Good luck, soldier. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
All our motors are weak (low voltage)
We have quite a few motors on our robot and they all have the same problem. We noticed they seemed weak, so we put a multimeter on them. They're cycling 5-7-9 volts, never getting to the full 12. However if we bypass the Jags & Victors the motors run much stronger and we measure 12 volts.
What could cause this issue in Labview? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode