|
Course tolerances
Posted by Erik Justen.
Engineer on team #128, Cold Fusion, from Grandview Heights and The Ohio State University/American Electric Power.
Posted on 2/7/2000 10:23 PM MST
Someone posted this a while ago, but I couldn't seem to find it.
Does anyone know where I can find tolerances for the course dimensions? Someone specified +/- 1
inch, but I can't seem to find that number anywhere in the documentation. Can anyone point me in the right direction?
Thanks,
Erik
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|