D-link Illegal Firmware (2.02)

[xisybyl]

How does one install new firmware? Also, how does one know if the router is actually resetting? We see no light activity when holding the rest down for 10+ seconds.

[Alan Anderson]

Originally Posted by Team156

We have been unable to find a working link to v2.03. If you have found one that works could you please post it.

ftp://ftp.dlink.com/Wireless/dap1522...vB_FW_203b.bin

I got there by browsing http://www.dlink.com/ and searching for DAP-1522, going to the product page, and selecting the Downloads tab.

[Schnabel]

So this is kinda related.

Our bridge has what I will call the red light of death at the moment and I wanted to see if anyone was able to help me with it.

I was able to run the configuration utility on the bridge without an issue and we successfully used the bridge without issues. Once we rebooted the robot the bridge refuses to boot with the red power light staying on (even on the AC adapter). I pressed and held the reset button while applying power to put the bridge into the firmware upload mode. I was able to load the web page without an issue, however every time I attempt to upload firmware it fails with the following message.

FAILED TO UPLOAD IMAGE

Unable to upload the image, please make sure the uploaded file is the correct image.

I believe I've read that you must unzip the file, however I have not been able to do that. Any suggestions?

[Alan Anderson]

Originally Posted by Schnabel

FAILED TO UPLOAD IMAGE

Unable to upload the image, please make sure the uploaded file is the correct image.

I believe I've read that you must unzip the file, however I have not been able to do that. Any suggestions?

What file are you trying to upload to the D-Link? Where did you get it? The one we've loaded into both of our Rev B DAP-1522s came from the link I posted above.