Shortening Cim Motor Axel

[Twins Inc.]

Are we allowed to trim down a Cim Motor axel (BAG Motor)? We're making a belt driven wheel thats in a tight spot and the axel is too long.

[bgg]

Yes. See rule below:

R33
The integral mechanical and electrical system of any motor may not be modified. Motors, servos, and electric solenoids used on the ROBOT shall not be modified in any way, except as follows:

The mounting brackets and/or output shaft/interface may be modified to facilitate the physical connection of the motor to the ROBOT and actuated part.
The electrical input leads may be trimmed to length as necessary.
The locking pins on the window motors (P/N: 262100-3030 and 262100-3040) may be removed.
The connector housings on the window motors (P/N: 262100-3030 and 262100-3040) may be modified to facilitate lead connections.
The Integrated Encoder Module (P/N: 276-1321) may be installed on the VEX 2-wire Motor 393 (P/N 276-2177).
The VEX 2-wire Motor 393 (P/N: 276-2177) gears may be changed or replaced per the Supplier instructions.

[DonRotolo]

Axel
Axle

Note the differences.

[Chris is me]

Frankly, I am beyond impressed that you found an application for the BAG motor where the shaft was too *long*. The short output shaft has been a problem for any of our potential uses.

[Cecil]

Originally Posted by DonRotolo

Axel
Axle

Note the differences.

Darn it, now I have to go listen to Axel's theme...

But I also have to agree with Chris. What on earth do you have attached to the BAG motor that can drive something, but still needs the shaft shortened?

[Johnny]

I can see the axle needing to be shortened if they are trying to fit it inside say a banebot or andymark planetary transmission. I don't see this as a strange question with that thought in mind.