Getting Potentiometer reading from CAN in Labview

[saulwold]

Hi there,

We are trying to read a potentiometer via the CAN bus in Labview. When we hook up the Jaguar directly to BDCcomm, it reads the values correctly, we can also get the values of the potentiometer from the Analog Card on the cRio via Labview code and driver station, but when we try to use the Jaguar CAN VI codes in Labview it returns 0 values from the "Get Status" VI.

We have set the CAN Jaguar up for Position and Potentiometer, we have tried setting POT Turns to 0 and 1, seems to make no difference. All the values from GET Status report 0, while if connected to BDCComm we get valid values.

Thanks
Sau!