talon rapidly flashing yellow

[lemonzap]

we recently finished hooking up the electronics on our practice robot and when we turn it on one talon flashes yellow very quickly. it is not connected to a pwm. using a multimeter the power flow appears to be stable but it may not be updating fast enough. does anyone have any idea whats going on?

[frasnow]

http://www.crosstheroadelectronics.c...Manual_1_1.pdf

The LED will blink orange any time the Talon is in the disabled state. This will happen if the PWM input signal is lost, or in FRC, when the robot is disabled.

[lemonzap]

Originally Posted by frasnow

http://www.crosstheroadelectronics.c...Manual_1_1.pdf

its not that kind of blinking. the talon blinks slowly in that state. currently its blinking very rapidly. i have done some testing and confirmed that the problem is on the talon.

[plnyyanks]

Originally Posted by lemonzap

i have done some testing and confirmed that the problem is on the talon.

Can you elaborate on what troubleshooting you've done?

[lemonzap]

Originally Posted by plnyyanks

Can you elaborate on what troubleshooting you've done?

weve tried with and without pwm connection, multiple different fuses and pd ports, different batteries, different power wires, and continuity tested the power wires. weve come to the conclusion that the talon must be broken.

[cgmv123]

PM Mike Copioli on this forum.

[CalTran]

Hey this is sorta a thread revival, but we have a talon that, when enabled, has a red blink to it. It's the same blink to it that you would get if you're running the talon slow reverse. However, when we move the PWM to another talon, it goes solid yellow, as it should. Any answers?

[Alan Anderson]

If a speed controller doesn't output "neutral" when it's told to, the first thing to do is to calibrate it.

[Mike Copioli]

Originally Posted by CalTran

Hey this is sorta a thread revival, but we have a talon that, when enabled, has a red blink to it. It's the same blink to it that you would get if you're running the talon slow reverse. However, when we move the PWM to another talon, it goes solid yellow, as it should. Any answers?

Calibrate your talon.

[CalTran]

Originally Posted by Mike Copioli

Calibrate your talon.

I figured it was uncalibrated.