|
|
|
 Your robot weight goes up after you release the balloons. Re-inspection! - GaryVoshol [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Your robot weight goes up after you release the balloons. Re-inspection! - GaryVoshol [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
No "Install New Software" in Workbench
Hello all,
I have been posting some questions about C++ and I have several more involving command-based programming (for time sake, CBP) because several people has said that it is easier and better. I went to go explore CBP and was following the "Installing the Workbench Plugin" (located here guide but when I went to go install the plugin, there was no "Install New Software..." button in "Help". Does the FRC Tools or Wind River Workbench need to be reinstalled? FYI, I am running Wind River Workbench 3.3. Thanks in advance. Last edited by austpet1230 : 24-03-2013 at 16:21. 
|
|
#2
24-03-2013, 22:14
|
|||
|
|||
|
Re: No "Install New Software" in Workbench
Looks like you are in the Basic Device Development perspective.
Window->Open Perspective -> Advanced Device Development. You should then see it in the menu.
|
|
#3
25-03-2013, 06:29
|
||||
|
||||
|
Re: No "Install New Software" in Workbench
Ok, it works now. Thank you very much.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
