|
|
|
 Remember FIRST is "For Inspiration" of all students. It is a little tough to inspire students you won't allow in. - pafwl [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Remember FIRST is "For Inspiration" of all students. It is a little tough to inspire students you won't allow in. - pafwl [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Export capabilities of SolidWorks?
Hi, can anyone tell me if SolidWorks allows IGES or STEP export in the student edition used by FIRST students?
|
|
#2
27-03-2013, 18:18
|
||||
|
||||
|
Re: Export capabilities of SolidWorks?
I not an expert on Solidworks, but as far as I can tell it is possible to save a part as either an IGES or STEP file. At least in the 2012 Student Edition.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
