1114's Red Ribbon?

[YCJeon772]

I cant believe it took a good 10 minutes to find the new thread button...
But anyways, I was just wondering what that red ribbon on 1114's climber was for. I thought that it was used to pull the arm in, but I may be wrong. And if it is used to pull the arm back, how does that work?

[Kevin Sevcik]

I have no detailed knowledge, but just based on the speed of climbing, I'm guessing the red strap was wrapped around a pulley that was driven by a power takeoff connected to their drivetrain. So they were using the full power of their drivetrain to lift the robot.

[Joe G.]

http://www.simbotics.org/first/2013

No PTO. Strap is used to retract the arm.

[Boe]

Originally Posted by Kevin Sevcik

I have no detailed knowledge, but just based on the speed of climbing, I'm guessing the red strap was wrapped around a pulley that was driven by a power takeoff connected to their drivetrain. So they were using the full power of their drivetrain to lift the robot.

1114s climber was powered by a gearbox using 2 cims and 2 mini cims i believe

[Gregor]

Constant force springs extend the climber, winch powered by 2 cims and 2 minicims retract the climber via the red straps.

[Cash4587]

I have confirmed they use constant force springs to extend it. I just dont understand how, none the less. Well this link will really help there are some great close ups if you were wondering. https://www.dropbox.com/sh/3fxabc28nvvkcr8/A2tQie9tgK

[Chris is me]

Originally Posted by Cash4587

I have confirmed they use constant force springs to extend it. I just dont understand how, none the less. Well this link will really help there are some great close ups if you were wondering. https://www.dropbox.com/sh/3fxabc28nvvkcr8/A2tQie9tgK

When a mechanism is run with a winch and pulley + some springs, the "pull" motion is simple - winch winds rope in, mechanism comes with it. To extend, you just run the pulley in reverse. The springs take up the slack in the rope and extend the mechanism.

[mman1506]

does the shaft at the rear of there robot serve as part of a function or is it a structural component?

[Gregor]

Originally Posted by mman1506

does the shaft at the rear of there robot serve as part of a function or is it a structural component?

Outer attachment point for their hanger. Slide it out, hanger comes out.

[mman1506]

Originally Posted by Gregor

Outer attachment point for their hanger. Slide it out, hanger comes out.

That's quite elegant, do you know what they use to pivot the arm up and down?

[Pratik Kunapuli]

Originally Posted by mman1506

That's quite elegant, do you know what they use to pivot the arm up and down?

They use a piston to move it up and down.

[apples000]

This is a little unrelated, but does anybody have a good, high quality video of 1114 climbing?

[Pratik Kunapuli]

Originally Posted by apples000

This is a little unrelated, but does anybody have a good, high quality video of 1114 climbing?

https://www.youtube.com/watch?v=oMBTmfBnjsc

Go to about 1:20. It's also in 1080p, but it doesn't show the dump.

[orangemoore]

I think that could be the bottom connection point for their climber.

[Joey Milia]

Originally Posted by mman1506

does the shaft at the rear of there robot serve as part of a function or is it a structural component?

It looks to me that it's the shaft the climber is mounted to and pivots on.