Bevel Gears on Drivetrain

23-06-2002, 22:57

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Bevel Gears on Drivetrain

Posted by Michael Quayle at 1/14/2001 10:57 PM EST

Engineer on team #253, MRT, from Mills High School.

We were considering using bevel gears on a drill motor, but the bevel gears sold by SmallParts are very small (in terms of the bore diameter). What are the advantages/disadvantages of using bevel gears on a drivetrain?

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Need an EDU Beval Gear	CD47-Bot	Robot Showcase	8	30-10-2003 14:03
drivetrain mouts and gears	Andrew Dahl	Technical Discussion	3	22-01-2003 13:21
Best source for gears? Smallparts? drivetrain advice wanted!	Frank(Aflak)	Technical Discussion	11	10-01-2003 17:22
Forward/Reverse difference in drill motors.	archiver	2001	15	24-06-2002 02:38
Need help! What kind of gears are we allowed to use??	Randy_Ai	Technical Discussion	3	23-01-2002 22:56

All times are GMT -5. The time now is 23:56.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.