|
Interchangable Motors?
Posted by rebecca at 1/19/2001 3:21 AM EST
Student on team #192, gunn robotics team, from gunn high school.
back in the "can i drill a hole in a motor shaft" thread, a few people mentioned having complete interchangability pertaining to motors. What kind of system allows that? set screws?
what we've done is have a keyway w/ key and keep a spare modified motor on hand. If we burn that spare too, we are screwed. But we've never even needed the one spare so...
Is there is a better way?
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
The urge to compete tends to drive teams to hold the ideas close during the competition season, but the urge to contribute means they get publicized afterwards. - Alan Anderson [more] 
Similar Threads
Threaded Mode