|
|
|
 Don't take things too seriously; It's supposed to be fun. :) - ScoutingNerd175 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't take things too seriously; It's supposed to be fun. :) - ScoutingNerd175 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: Mockup Set Created by my Gearbox Generator
I should have made one, unified thread. Forgive the mistake.  Link to generator description and download is here: http://www.chiefdelphi.com/forums/sh...d.php?t=123908 Last edited by wasayanwer97 : 03-01-2014 at 00:58. 
|
|
#2
03-01-2014, 17:26
|
||||
|
||||
|
Re: pic: Mockup Set Created by my Gearbox Generator
Sweet! Wo does it generate the entire model or does it just use existing ones, but fit different gear sizes?
|
|
#3
03-01-2014, 19:02
|
||||
|
||||
|
Re: pic: Mockup Set Created by my Gearbox Generator
There is a part file for the gearbox plates. That part file then changes when you input your selected gear sizes into the JVN calculator and save it. Different gear sizes, and the needed hole spacing are then determined/accounted for.
In the end it will have generated/modified a gearbox plate, a representation for every gear, and and a dummy assembly like the one shown that shows how they would fit together.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
