90 degree robot modem connector

24-06-2002, 00:03

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

90 degree robot modem connector

Posted by Rob DeCotiis at 2/2/2001 3:37 PM EST

Student on team #504, RoBUCtics, from Red Bank Regional High School and Jesel.

Are we allowed to use a 90 degree angle robot modem connector(a connector that allows the robot modem to be mounted vertically without having the control board mounted vertically as well)???

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How much planning goes into your robot?	Jnadke	General Forum	41	29-01-2006 21:29
serious problem found - robot controller resets when jarred!	KenWittlief	Electrical	23	19-03-2003 13:30
WASH Palm scouting at the Championship	Mike Soukup	Scouting	2	19-04-2002 15:14
Index of team's post about their robot...	Ken Leung	Robot Showcase	1	20-03-2002 17:10
about how Drive Train push the robot... shouldn't the force accelerate the robot?	Ken Leung	Technical Discussion	12	26-11-2001 09:39

All times are GMT -5. The time now is 00:12.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.