Connecting hub sprockets to shafts

I HAVE ENERGY DRINKS AND STARBUCKS COFFEE!!! I'M READY!!! - looneylin [more]

		Chief Delphi > Old Forum Archives > 2001
Connecting hub sprockets to shafts

Thread Tools

Rate Thread

Display Modes

24-06-2002, 00:03

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Connecting hub sprockets to shafts

Posted by Patrick Dingle at 2/2/2001 7:17 PM EST

Other on team #639, Red B^2, from Ithaca High School and Cornell University.

Does anyone know the most reliable way to connect a hub sprocket to a rotating shaft (no keyway)? We are planning to drill and tap the hub, and bolt slightly into the shaft. Is this reliable, or are there better ways?

Thanks
Patrick

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
modifying sprockets	gail	OCCRA	3	05-10-2002 12:13
shafts, gears and wheels....	archiver	2001	13	24-06-2002 04:09
Re: Connecting hub sprockets to shafts	archiver	2001	1	24-06-2002 00:20
5/16" cold steel shafts...	archiver	2001	3	23-06-2002 23:17
Which form of connecting a rod to a wheel is the best?	SilverStar	Technical Discussion	2	27-03-2002 20:30

All times are GMT -5. The time now is 14:19.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.