Hey guys, this is my first post on Chief Delphi and I've got a question concerning the chassis included in the KOP, the AM14U. We got it on Thursday (we're from Chile, so we get things later
) and built it the same day. We also got the basic electronics mounted and programming on the cRIO, so we started driving straight away. We tested it and found out that the frontal wheels were slightly lifted up from the ground. So our CAD subteam sketched the chassis in Inventor based on the files from the AndyMark webpage and realized that the ToughBox shaft was 0.14" higher than the center of the outer wheels. Is this a design error, or is it intentionally designed in that way?
Sometimes i wish the robot could fit into my pocket. - GMAdan [more] 
Threaded Mode