Talons flash red on enable

When I'm hiring an intern "Award Winning VRC Notebook" isn't applicable. But "Award winning technical documentation" sure is. - Andrew Schreiber [more]

		Chief Delphi > Technical > Electrical
Talons flash red on enable

Thread Tools

Rate Thread

Display Modes

23-01-2014, 19:32

DDSLoan96

Jack of all trades

AKA: Danny

FRC #1468 (J-Birds)

Team Role: Mentor

Join Date: Dec 2010

Rookie Year: 2010

Location: Hicksville

Posts: 40

DDSLoan96 is an unknown quantity at this point

Talons flash red on enable

Today we were planning on having the robot running around but we have hit a bit of a snag. When we enable our robot all of our Talons flash Red which means there is a fault. The only thing we see in the Talon manual is that it could be either low input voltage(checked we get 12 volts at each), over temperature(Cold to the touch) or a shorted output transistor. What can I do to fix this

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:10.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.