We NEED 8-inch wheels and programming help

There is no rule that specifically states that you must obey the law of physics during the competition. This may be an oversight. - bmather [more]

		Chief Delphi > Old Forum Archives > 2001
We NEED 8-inch wheels and programming help

Thread Tools

Rate Thread

Display Modes

06-24-2002, 12:29 AM

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

We NEED 8-inch wheels and programming help

Posted by Dan Rich at 2/8/2001 4:34 PM EST

Student from Warren County Vo-Tech.

Hey everybody. I'm from Team 550 in NJ, and we need a couple more 8 inch wheels. Anybody know where to get them? We would also like some help in getting two motors seperately controlled by one controller, one on the x-axis and one on the y-axis. Thanks.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how does crab drive work?	Soukup	Technical Discussion	13	04-25-2003 11:31 AM

All times are GMT -5. The time now is 10:34 AM.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.