|
|
|
 Any adult can open a door. Some can give direction. A few can give leadership. These are the true mentors. This is where true success comes from. - sanddrag [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools |
Rating: 
|
Display Modes |
|
#61
|
|||
|
|||
|
Re: Good Material For Bottom of Chassis
I like a nice piece of aluminum or steel/stainless. We've been doing 1/4" aluminum lately.
But I'm a control panel guy, I'm pretty attached to my metal back plates and my Greenlee DTAP kit. |
|
#62
17-01-2015, 02:54
|
||||
|
||||
|
Re: Good Material For Bottom of Chassis
We used carbon fiber for a few years... however we did have a sponsor that just gave it to us for free which is nice because it can be very expensive. The only issue we had was that it was conductive so we velcroed electronics down. It was super light and we had the right stuff to cut it with.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
