|
|
|
 When motors stall, bad things happen. - Rob Stehlik [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| When motors stall, bad things happen. - Rob Stehlik [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Digital Module Power Issue
We have a photoswitch diffuse sensor that uses at least 11V of power to run. The sidecar D I/O on our robot only provides 5V. Is there a way to change this or does the digital module only supply 5V to each component?
|
|
#2
21-01-2015, 18:53
|
||||
|
||||
|
Re: Digital Module Power Issue
You can't get 12v from the roboRIO, but there's nothing preventing you from powering the sensors off of the 12v rail of the VRM.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
