|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Turntables
So, in the rules it was stated that it was against the rules to have more than 2 degree freedoms. We're using the P/N 276-1810 Turn Table bearing kit, and to our knowledge, it's a first degree freedom. If we use two of these, would it could put together as a two degree freedom, or two one degree freedoms? Please answer this as soon as possible, thank you!
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|