victors

[great_one411]

How do you connect the pins from the victors to the robot controller, specifically which pin location 1-8.

[Andrew Rudolph]

You need to look through FIRSTs documentation on usfirst.org and innovation first at firstrobotics.com

but for now...You use pwm cables(3 strands with a little plug, make sure u put them in correctly, the rc says which pin goes to which color) , you plug them into whatever pin you want look at your code.

[Katie Reynolds]

Originally posted by Andrew Rudolph
but for now...You use pwm cables(3 strands with a little plug, make sure u put them in correctly, the rc says which pin goes to which color) , you plug them into whatever pin you want look at your code.

Just FYI, the PWM cables that came with this year's kit are red, white, and black.

- Katie

[wwrye]

If I'm not mistaken the PWM y-cables are yellow/red/black. The y-cables are used to send the same signal off one PWM output(on the RC) to two different speed controllers.

[Al Skierkiewicz]

Please look here and download all the documents if you haven't already. You should keep them handy always.

http://www.innovationfirst.com/FIRST...ence_Guide.pdf