|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
we are using the default program and the wheels keep spinning in reverse. please help us
![]() |
|
#2
|
||||
|
||||
|
One solution, I believe, would be to switch the polarity of the motor at the speed controller. That is, unscrew the M+ and M- terminal leads, and swap them.
|
|
#3
|
|||||
|
|||||
|
You might also want to trim out the joysticks.
There are small dials (potentiometers) on each axis of the joystick. If these dials are not centered than the motor will move even when the joystick is positioned in the resting center of the base. - Mike |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2-week FIRST summer program @ WPI | ColleenShaver | General Forum | 20 | 31-05-2009 03:02 |
| Fried program slots? | Jeff Waegelin | Programming | 18 | 19-03-2003 18:08 |
| default program | Billyp04 | Programming | 26 | 14-01-2003 15:48 |
| Ahh! Program trick confusing! | archiver | 2001 | 9 | 24-06-2002 02:26 |
| robot control emulator for default or other program | CharlieWilken | Programming | 26 | 24-02-2002 02:36 |