Help Help Please A.S.A.P

[jrock24jr]

Where can I find the correct required dimensions to the project box of the control panel?


Thank You
DeAnza Robotics

[Lloyd Burns]

There are two boxes this year:
_____The one on which you place operator controls, which will be connected to your Operator Interface, can be anything (or nothing) and it is completely up to you.
_____The one on the robot was specified in message 143 (?) on FRCtech2002. It _must_ be a Bud PN-1324-C, which is available from DigiKey and other fine establishments everywhere. I posted earlier about this NEMA4 box, which has a clear top, and is roughly 6"x4"x2".