|
|
|
 I, as a programmer, always strive to have the entire robot operate with as little driver input as possible. Those pesky humans.... - dellagd [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I, as a programmer, always strive to have the entire robot operate with as little driver input as possible. Those pesky humans.... - dellagd [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Inventor 5.0 help needed
Can I take an assembly (or collection of assemblies in an assembly) and sketch on it?
I have a partial model of the robot and want to sketch adaptively another subsystem. Right now, all I know how to do is make parts (like angle or tubes of a certain length) and assemble them. Another question: how does one make an angle or tube adaptive so it stretches/shortens as needed to fit in a space? At the moment I have to extrude a certain distance and then use the part as is, maybe triming after using. Larry Barello Team 492 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chamionship Qualification - feedback needed ASAP! | dlavery | General Forum | 97 | 11-10-2003 07:17 |
| The Grand FIRST team.. programmers and others needed | randomperson | Programming | 0 | 31-05-2003 23:46 |
| TechnoKats' designs - responses needed | Andy Baker | Chairman's Award | 0 | 29-01-2003 09:52 |
| Weight needed to tilt bridge... | archiver | 2001 | 4 | 23-06-2002 23:43 |
| Battlecry 3 volunteers needed? | Hymnson | Off-Season Events | 4 | 02-06-2002 12:38 |
Threaded Mode