|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Team 449 has developed a Tcl/Tk based graphical code generation interface for programming our robot. The interface has been tested on Linux and Windows systems, although auto-compiling and downloading to the Basic Stamp on the RC works only under Windows (for obvious reasons).
To operate under Windows, ActiveTcl and Cygwin (Google searches should suffice) are required. Modfiy the path to the working directory on the next to last line in serin.tcl. An archive of the code is available at http://robot.mbhs.edu/computers/robotcode.zip Questions/Comments may be addressed to ebaer@mbhs.edu, or alternatively, robocore@mbhs.edu. Last edited by ebaer : 28-01-2002 at 15:50. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming Compatition | Angela06 | Programming | 30 | 08-04-2005 23:12 |
| Looking for operator interface... Where is it? | mike325 | General Forum | 2 | 07-01-2003 15:28 |
| Operator Interface is crazee !!! HELP | punarhero | Programming | 30 | 17-07-2002 14:23 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
| pbasic programming | punarhero | Programming | 4 | 21-01-2002 23:32 |