|
|
|
 Check Chief Delphi, and if there isn't a post, make one. - sithmonkey13 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Check Chief Delphi, and if there isn't a post, make one. - sithmonkey13 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Analog Inputs
Hello all,
I have a problem, I don't know how to get data from the analog inputs. any info. would be helpful. |
|
#2
04-02-2002, 20:12
|
|||||
|
|||||
|
You need to first wire it according to the manual (correct pins +5, GND, and the signal) Go to the initialization area and for the sensor you want to read make it CON 1. Then add the sensor you are using to the serin command (Sensor 1 and up). Presto you have the data.
email me if you have any problems Matt |
|
#3
05-02-2002, 05:53
|
|||
|
|||
|
Lloyd Burns
Check out this little tutorial:
How to enable the RC Analog Inputs http://www.team188.com/cr/forum/tech...sages/51.shtml |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to access other Digital inputs on OI? | DougHogg | Electrical | 2 | 12-03-2003 13:57 |
| Digital inputs, bandwith, errors? | Micah Brodsky | Programming | 7 | 20-01-2003 16:08 |
| Change to Initializing Inputs and Outputs | Jferrante | Programming | 4 | 07-01-2003 11:36 |
| Analog vs Digital inputs? | f22flyboy | Programming | 8 | 08-11-2002 22:18 |
| Serious Controller Ideas | archiver | 1999 | 28 | 23-06-2002 23:01 |
Linear Mode
