|
|
|
 Andy, you have daughters, would you buy them a Dave doll? - MissInformation [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Andy, you have daughters, would you buy them a Dave doll? - MissInformation [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
06-02-2002, 16:12
|
||||||
|
||||||
|
Search please
Try searching on "drill motor gear" see what you get.
About 40 messages, at least 3 of which have the information you want. Joe J. |
|
#3
07-02-2002, 11:05
|
||||||
|
||||||
|
after a search...
After doing a quick search...
"Before you ask, the drill motor is a standard, 0.7 module, 20 degree pressure angle, full depth gear. " -Joe J http://www.chiefdelphi.com/forums/sh...&threadid=1635 Should've been part of the newsletter, but some how I managed to skip that... Oh well. Posted in here so people can see it for a while before this post will be pushed back by new ones. |
|
#4
07-02-2002, 12:51
|
|||||
|
|||||
|
Speaking of the drill motors.
Does anyone know the thread size of the center of the tranny coupling? We can see it's a left-handed thread but we have no screws with left-handed threads. We are mounting a gear directly to the output shaft, but need a screw to secure it. Any help would be appreciated. Wayne Doenges |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| drill motor specs | Caitlyn691 | Motors | 34 | 17-01-2003 13:33 |
| Specs for drill motor gearbox? | archiver | 2000 | 4 | 23-06-2002 22:36 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Linear Mode
