|
|
|
 "So we have an arm, and the pot on it tells how high we are...
...and then we know how high we want to be...
...and if we're not high enough we go higher."
(I have to leave the room, we're all laughing too much.) - demosthenes2k8 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
How to make gears mesh properly.
Let's say you have a gear with a pitch diameter of 1" and then you have another one with a pitch diameter of 2". Would you place these gears exactly 1.5" apart? Or would you leave a few thousandths for backlash? Is a little backlash already accounted for in gear sizes? If you must account for it yourself, how do you know how much more to put them apart? Thanks
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What type of steel are gears commonly made from? | Matt Adams | Technical Discussion | 5 | 02-01-2004 23:19 |
| Best source for gears? Smallparts? drivetrain advice wanted! | Frank(Aflak) | Technical Discussion | 11 | 10-01-2003 17:22 |
| Please help make the Nationals in Houston AWESOME ... You be the Tournament Director | Natchez | General Forum | 42 | 13-12-2002 18:50 |
| Time for new rules! | archiver | 2001 | 11 | 24-06-2002 02:01 |
| How do i make gears in inventor? | mnkysp6353 | Inventor | 1 | 16-01-2002 02:31 |
Threaded Mode