|
|
|
 I also hate it when I keep seeing this message: "You must spread some Reputation around before giving it to Andy Baker again." - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I also hate it when I keep seeing this message: "You must spread some Reputation around before giving it to Andy Baker again." - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Question on Pneumatic Cylinders
I don't think this question has been asked yet on this forum, but if it has, please pardon my ignorance and point me to the correct thread. Our current design incorporates two 1/2" bore cylinders that we discovered among our other cylinders. Does anyone know if these were considered legal parts from a previous year (and therefore going through the 2004 Part Use Flowchart) making them legal parts this year?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A question about control system options | computhief263 | Control System | 7 | 04-02-2004 14:46 |
| Custom pneumatic cylinders | duckshepherd | Pneumatics | 7 | 24-01-2004 20:39 |
| LAST MINUTE Pneumatic Question | archiver | 2001 | 6 | 24-06-2002 01:11 |
| Beatty and Kingman | JAlpert | Regional Competitions | 51 | 08-04-2002 16:59 |
| servos, chapulas, cylinders and Skyway...in other words... | Jessica Boucher | Motors | 7 | 14-01-2002 19:36 |
Threaded Mode