|
|
|
 If nothing's going wrong, then there is something seriously wrong. - Astronouth7303 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| If nothing's going wrong, then there is something seriously wrong. - Astronouth7303 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Reconstructing the Drill Motors After Removing the Clutch.
At the risk of embarrasing myself,
Im having some trouble with the drill motors. We followed the guide to removing the clutch on our drill motors. Then enters our problem. I think theyre broken...but in anycase i dont know how to uh....reassemble them. Any Help would be greatly appreciated..... HELP!!! Nick Team 610 |
|
#2
28-01-2004, 18:19
|
|||
|
|||
|
Re: Reconstructing the Drill Motors After Removing the Clutch.
Did you see the powerpoint under the Spec Sheets section of the FIRST site? Just follow that.
|
|
#3
28-01-2004, 22:15
|
|||||
|
|||||
|
Re: Reconstructing the Drill Motors After Removing the Clutch.
Quote:
The trans only goes back together one way and the clutch ring only fits through the end cap one way. You also may have a problem with the gears/coupling not meshing. Try turning the output shaft while you push the two halves together. It might take a third hand to turn while you put the parts together. Don't get frustrated, just take your time, it will go together. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Automatic Transmission" | Madison | Technical Discussion | 70 | 24-11-2003 09:03 |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| what about the drill motors? | Ken Leung | Motors | 2 | 26-06-2001 02:11 |
Linear Mode
